Type2 Split Bay T25 Distributor drive pinion Type1 engines from 1964 and WBX 113105231B
Fits:
Type-1 engines 8.1964 and later except 30hp engines
Type-3 engines
CT/CZ engines
Waterboxer engines
If the distributor drive pinion is damaged, there is a risk that the ignition timing will be off, which can be fatal to your engine. As with any engine part, an accurate inspection is required, which saves a lot of trouble later on. Make sure your old drive pinion is reusable and replace it if in doubt.
To remove the pinion from the crankcase and later also to replace it, an extractor is not an unnecessary luxury. Without this extractor, the work will take a long time, with the extractor it is a matter of minutes.
Note: First place the adjusting rings in the crank. Use a little grease to hold the adjusting rings in place when mounting the pinion. Then insert the pinion into the crankcase. If you want to place the rings around the pinion in the crank afterwards, you will find that you cannot pass behind the pinion.
